The photo (above) shows the minor body modification made for clearance on the Atlas.

The stock console will require disassembly and the stock transfer case linkage will need to be removed.clearance.

This photo shows the Jeep console removed and the transfer case linkage removed.

Floorboard modifications are necessary to fit the Atlas twin sticks. This photo shows 1" of material removed from the right side and front of the stock hole. (.500" needs to be removed from the left side)

Once the floorboard has been modified, it should look like the photo shown here.

Since the stock floorboard hole is longer than needed, we recommend using a piece of sheet metal to cover the rear 1" section of this stock hole. (photo shown above).

Test fit the Atlas shift handles. If proper clearance has been obtained, screw the rubber boot and ring to the floorboard. Note:The boot ring will need to be cut in half for proper fit to your floorboard.

Since the stock transfer case shift indicator cover will not fit with the Atlas twin-sticks, we modified this cover. Remove the indicator panel and cut the plastic that supported the indicator panel. Ideally, the plastic housing that snaps into the console is what your trying to retain. We purchased a small piece of black plastic from a local stereo installation shop and cut it to fit our plastic housing. We heated it to fit the contour and glued it into position. We then cut new access holes in the black plastic to fit our twin sticks.